haha no its not in there tight, it was there as a indicator for the picture.
i ordered one of those ones off ebay after "seeing if it would fit" from their list so will see what happens.
haha cheers guys
What was i ment to put in this hole ;)
-
dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: What was i ment to put in this hole ;)
Should fit. Its just a switch so common to a lot of vehicles I would assume.
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
Re: What was i ment to put in this hole ;)
Jordi wrote:Seriously? How do you know this shit?ScottieJ wrote:I hope you didn't thread that bolt in tightly.
It's a 1/8 bspt thread on the sender so if you did you might have damaged the thread in the block.
I was just pleased i beat everyone to the correct answer.
because I'm a Suzuki nerd!