Gearbox removal easiest way?

Starts at the flywheel, ends at the hubs, any problems along them lines, ask your questions here.
Post Reply
User avatar
africanbiker
Got muddy boots
Got muddy boots
Posts: 5
Joined: Wed Aug 24, 2011 9:59 pm
Location: Horsham W Sussex

Gearbox removal easiest way?

Post by africanbiker » Wed Sep 07, 2011 10:24 pm

Is it easier to take the engine out to change a box, or remove the transfer box etc as my haynes suggests?

I'm new to SJ owner ship so any suggestions welcome.

:thumbup:

User avatar
ScottieJ
The Boss
The Boss
Posts: 11617
Joined: Tue Apr 15, 2008 12:13 pm
Location: Chippenham, wiltshire

Re: Gearbox removal easiest way?

Post by ScottieJ » Wed Sep 07, 2011 10:49 pm

Tbh honest there isn't much difference, if you have access to a engine crane id just whip the engine and gearbox out in one unit, if not then its not hard to just take the gearbox out on the floor, don't even need to remove the tbox but it does make it a bit easier if you do.

On a ramp I can do a clutch in under 1hour so it'll prob take around 2 on the floor.
Zuki Build

Steady as she goes!

User avatar
twiss
SCUK Computer Wizard
SCUK Computer Wizard
Posts: 6110
Joined: Mon Nov 08, 2010 2:28 pm
Location: Birkirkara, Malta
Contact:

Re: Gearbox removal easiest way?

Post by twiss » Thu Sep 08, 2011 12:44 am

It's a piece of cake, even from underneath! I've had to replace my clutch twice on this one, and one on my last SJ!
All done on the floor...

I should be more careful with clutches I think!
Twiss

'93 Suzuki Samurai Sport 1.6 16v SU. Virtual lift, spring under, 31s
'93 Maruti Gypsy MG410

"If brute force doesn't fix your problem, you aren't using enough of it."

Post Reply