Page 4 of 4
Re: handbrake on 410 it was a seized cable
Posted: Wed Apr 17, 2013 10:26 pm
by Jordi
Bit of a thread hi jack now.
I had both backing plates Darrell but to make life easy i gave my Jap SJ reg to the motor factors to identify parts and got sent jap shoes. They wouldn't fit the spanish backing plate, only fit jap plate with a minor adjustment.
I have two drums aswell but neither has a hole in them.
Re: handbrake on 410 it was a seized cable
Posted: Wed Apr 17, 2013 10:34 pm
by Darrell
Drill it is then
Re: handbrake on 410 it was a seized cable
Posted: Wed Apr 17, 2013 10:37 pm
by Jordi
I'm getting a few bits done at a local engineering place so may have them drill it out. Save me knackering mine. Just need measurements.
Re: handbrake on 410 it was a seized cable
Posted: Thu Apr 18, 2013 8:58 am
by dazerede
Here u.are jordi
I measured from centre of the drum out and it was 70mm
With a 12mm hole
Re: handbrake on 410 it was a seized cable
Posted: Thu Apr 18, 2013 11:00 am
by Jordi
Sound! Thanks bud!
Re: handbrake on 410 it was a seized cable
Posted: Thu Apr 18, 2013 9:33 pm
by dazerede
No worries jordi
Hand brake is working
Replaced the shoes with better ones (not new )
It all works MOT here I come
Re: handbrake on 410 it was a seized cable
Posted: Thu Apr 18, 2013 10:07 pm
by ROBBIE
Good work
Re: handbrake on 410 it was a seized cable
Posted: Thu Apr 18, 2013 11:17 pm
by Jordi
Be driving it on the road soon enough. Got the MOT booked?
Re: handbrake on 410 it was a seized cable
Posted: Thu Apr 18, 2013 11:51 pm
by turbo-tom
Remember to tell the mot tester you have a transmission handbrake! Otherwise you get what I got the mot tester trying to test the handbrake effiency on the rollers and wondering why he wad getting a bad reading aka a failure. Until I told him that you cant really test them
Best of luck on the mot she will be fine
