Evening all
I have just had my vitara head skimmed and was most of the way through reassembling it I have put new stem seals and lapped valves etc put everything back together and now it's time to do the clearances but now I'm a bit stumped I've googled it but to no avail.
Can some one point in the right direction to either a guide or a little write up on it.
Also I school bored it I took the camshaft pulley off with out paying much attention and when refitting it I noticed it had to key ways in it on numbered 60a and the other 80 c the engine is 1.6 8v on a 99. I noticed it had 61a on the head not sure if related or not.
Any help would be much appreciated.