Page 1 of 1
rascal rears lift question.
Posted: Wed Sep 04, 2013 3:17 pm
by duncslow
How much lift do rascal rear springs give on a 410. looking at fitting them on the back and buying new front springs to match cause I have the rascal rears and trying to keep to some sort of budget. I have looked at rears up front and its a lot of fabrication to make them work and I dont like the way the helper spring sticks out. I am hoping for a bolt on/easiest way of getting a bit more lift to save the underneath of the car.
Regards Chris
Re: rascal rears lift question.
Posted: Wed Sep 04, 2013 3:46 pm
by Edweird
I think it's about 1.5 to 2 inches.
Re: rascal rears lift question.
Posted: Wed Sep 04, 2013 4:19 pm
by windsor
Yeah bout 1.5 / 2inch ruf gives good flex tho
Re: rascal rears lift question.
Posted: Wed Sep 04, 2013 9:04 pm
by Jordi
You could always fab up a RUF kit and mix and match the spring pack removing the helper spring.
Re: rascal rears lift question.
Posted: Wed Sep 04, 2013 9:52 pm
by ScottieJ
Being a 410 it's pretty easy to make an ruf set up.
Plus you should remove the helper spring when you do it anyway as it serves no purpose on the front.
Re: rascal rears lift question.
Posted: Wed Sep 04, 2013 9:53 pm
by Jordi
Just rob Scotties bolt on front YJ design. Be easy to make that work for RUF.
Re: rascal rears lift question.
Posted: Wed Sep 04, 2013 9:57 pm
by ScottieJ
Will need to be done differently to work with SJ width springs but I could maybe knock something up.
Re: rascal rears lift question.
Posted: Thu Sep 05, 2013 8:13 pm
by duncslow
Its all circumspect now, scrap thieves robbed both my rascal springs and my spare sj rears this afternoon from my garden. Thanks for the replys chaps. going to have to start collecting springs again.