Suzuki Club UK

Had to do the clutch on my samurai and notice as I took the clutch plate off this bearing was buggered . It has got a vitara 1.6 eight valve in it the engine code is g16a . Any help would be much appreciate . Cheers
Liam

From what I can find it should be a double sealed 10x30x9mm bearing. same as on the sj410.

the code is 6200 2rsr

ScottieJ wrote:From what I can find it should be a double sealed 10x30x9mm bearing. same as on the sj410.

yes, I was also wondering why that bearing has no seal.

Rhinoman wrote:

ScottieJ wrote:From what I can find it should be a double sealed 10x30x9mm bearing. same as on the sj410.

yes, I was also wondering why that bearing has no seal.

could be why it's no longer any good

Nice one ! Thanks Scott . Other thing I was meant to ask , was can you run without it ?

Tregembio wrote:Nice one ! Thanks Scott . Other thing I was meant to ask , was can you run without it ?

I would not run it without one, it supports the gearbox input shaft, plus for a £5 component it's not really worth the risk.

I had the same problem with mine when i changed the gearbox. Just took the remains of the bearing to my local bearing supplyer and they were able to match it up with one off the shelf.

The question is... where did the other ball bearings get to???

Nowhere, that's all you get

But the cage has gone walkies..

Yeah didn't find the cage , seal or the other ball bearings :/ never mind . Bearing should be here today and all being well she will be back on the road thanks again .
Liam