Muddy good weekend - 25-26th April 2015 (Formerly Billing)
- Kermes-vermilio
- Got muddy boots
- Posts: 34
- Joined: Tue Dec 02, 2014 7:37 pm
Re: Muddy good weekend - 25-26th April 2015 (Formerly Billin
I think I'm ready! Didn't give the vit any more coats of paint so still a little patchy but its all good!
Expecting some nice weather for it :-)
What time are people planning on getting there/setting off to go there?
Expecting some nice weather for it :-)
What time are people planning on getting there/setting off to go there?
- dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: Muddy good weekend - 25-26th April 2015 (Formerly Billin
Between midday Sunday and last night I've had the transfer and gear boxes out and back in, inspected clutch and cleaned linkage, replaced wheel bearings on 3 corners and adjusted the 4th including removing shafts cleaning swivels and greasing CVs, transfer box now in RW cradle, stripped cleaned and tried to improve x-eng, went to remove a 2nd rear prop which turned out to be just as bad as my current one.
Tonight I need to do gearbox and diff oils, try to make rear prop slide fit tighter?!?!.......
Then she should be good.
Tonight I need to do gearbox and diff oils, try to make rear prop slide fit tighter?!?!.......
Then she should be good.
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
Re: Muddy good weekend - 25-26th April 2015 (Formerly Billin
I'm in the workshop tonight checking it over.
Do my usual...check fluids, give stuff a wobble to check for play, jack each wheel up to see if any bearings are noisy or have play.....
Might actually clean it?
Depending on the weather forcast might fit the half doors.
Do my usual...check fluids, give stuff a wobble to check for play, jack each wheel up to see if any bearings are noisy or have play.....
Might actually clean it?
Depending on the weather forcast might fit the half doors.
- Kermes-vermilio
- Got muddy boots
- Posts: 34
- Joined: Tue Dec 02, 2014 7:37 pm
Re: Muddy good weekend - 25-26th April 2015 (Formerly Billin
That's some good effort!
I tell a lie, I did actually adjust my handbrake because it didn't actually stop me from moving ha.
My gearbox is so rattly now, I am expecting this weekend to be the death of it
I tell a lie, I did actually adjust my handbrake because it didn't actually stop me from moving ha.
My gearbox is so rattly now, I am expecting this weekend to be the death of it
- donkeychomp
- I spend far too much time on here
- Posts: 3582
- Joined: Thu Aug 18, 2011 3:49 pm
- Location: Shepperton, Middx
Re: Muddy good weekend - 25-26th April 2015 (Formerly Billin
According to every weather thing I've checked it'll be chucking it down. Doors staying on!
If it ticks over...leave it
-
- I spend far too much time on here
- Posts: 3859
- Joined: Tue Jan 12, 2010 12:12 pm
- Location: London
Re: Muddy good weekend - 25-26th April 2015 (Formerly Billin
I want clear skies and sunshine over billing. Think Bahamas. Then I want torrential rain and maybe even a hint of severe flooding in Barton Le Clay. Think Noah.donkeychomp wrote:According to every weather thing I've checked it'll be chucking it down. Doors staying on!
Anyone living in/near Milton Keynes/Barton Le Clay, I am kidding, ok?
Sort of...
1985 SJ413VX (SJ50V) with SPOA, rear disc brakes, 31x10.5R15 Kaiman Malatesta tyres, an MOT and a lot left to do!
My: Build thread ● To-do list ● Pay and Play map
My: Build thread ● To-do list ● Pay and Play map
- Jordi
- Bow down before me
- Posts: 7535
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: Muddy good weekend - 25-26th April 2015 (Formerly Billin
At the moment it's half doors all the way!
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
- dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: Muddy good weekend - 25-26th April 2015 (Formerly Billin
Forecast started picking up this evening.
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
- dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: Muddy good weekend - 25-26th April 2015 (Formerly Billin
Probably leave Swindon around 3-4 depending what time Scottie makes it to mine. Anyone who wants to join the convoy from Swindon PM me for my address.
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
-
- I spend far too much time on here
- Posts: 3859
- Joined: Tue Jan 12, 2010 12:12 pm
- Location: London
Re: Muddy good weekend - 25-26th April 2015 (Formerly Billin
So far, I think you're winning the "did most stuff to prepare" trophy...dan_2k_uk wrote:Between midday Sunday and last night I've had the transfer and gear boxes out and back in, inspected clutch and cleaned linkage, replaced wheel bearings on 3 corners and adjusted the 4th including removing shafts cleaning swivels and greasing CVs, transfer box now in RW cradle, stripped cleaned and tried to improve x-eng, went to remove a 2nd rear prop which turned out to be just as bad as my current one.
Tonight I need to do gearbox and diff oils, try to make rear prop slide fit tighter?!?!.......
Then she should be good.
1985 SJ413VX (SJ50V) with SPOA, rear disc brakes, 31x10.5R15 Kaiman Malatesta tyres, an MOT and a lot left to do!
My: Build thread ● To-do list ● Pay and Play map
My: Build thread ● To-do list ● Pay and Play map