Number plate relocation
- combatkenz
- Got muddy boots
- Posts: 24
- Joined: Mon May 29, 2017 11:24 am
Number plate relocation
Hi Guys,
Does anyone have there number plate located on the bonnet and is it legal? I'm fitting a winch bumper so wanted to stick it to the front of the bonnet.
Does anyone have there number plate located on the bonnet and is it legal? I'm fitting a winch bumper so wanted to stick it to the front of the bonnet.
-
- I spend far too much time on here
- Posts: 3859
- Joined: Tue Jan 12, 2010 12:12 pm
- Location: London
Re: Number plate relocation
I think that some people have put the number plate on the windscreen lower surround, but I don't know the legality of that. On the bonnet it'll be difficult to see, so I would imagine that it's illegal, but I don't know for sure.
1985 SJ413VX (SJ50V) with SPOA, rear disc brakes, 31x10.5R15 Kaiman Malatesta tyres, an MOT and a lot left to do!
My: Build thread ● To-do list ● Pay and Play map
My: Build thread ● To-do list ● Pay and Play map
- timwilks13
- SCUK Website Padawan
- Posts: 1248
- Joined: Sun Feb 03, 2013 5:55 am
- Location: Scarborough, soon to be Poland
Re: Number plate relocation
I think there are rules on the angle of your plates so flat to the bonnet top I would be ruled as illegal. Whether you can squeeze it on the front of the bonnet so it sits upright or not I don't know, but as Anton said many go with it under the windscreen on the surround.
1986 SJ410 - Furry dice, new window winder.
10 kinds of people in this world, those who understand binary and those who dont.
if you can read this you're too close to the monitor, sit back and save your eyes!!
My build, formally Trotters build.
10 kinds of people in this world, those who understand binary and those who dont.
if you can read this you're too close to the monitor, sit back and save your eyes!!
My build, formally Trotters build.
- donkeychomp
- I spend far too much time on here
- Posts: 3582
- Joined: Thu Aug 18, 2011 3:49 pm
- Location: Shepperton, Middx
Re: Number plate relocation
Flat on the bonnet is illegal on an SJ. As I found out...
If it ticks over...leave it
- combatkenz
- Got muddy boots
- Posts: 24
- Joined: Mon May 29, 2017 11:24 am
Re: Number plate relocation
I’ve seen some stuck to the flat upright piece of the bonnet at the front.... that’s where I was going to mount it.
Re: Number plate relocation
Mine is stuck to the from of the Bonnet. I haven't had it long enough to mot yet but presumably it was ok for previous MOT. Will post a pic in a bit.
Re: Number plate relocation
https://flic.kr/p/23vhiYK
https://flic.kr/p/227shu3
Hopefully will have Been to MOT centre one way or another in the next week. Will let you know what was said about it then.
Only my old discovery I tried using both velcro and magnets to hold the number plate to the winch bumper (so that it could be removed for using the winch or pandp sites) but neither we able to stand up to water crossings or spray off deep puddles.
https://flic.kr/p/227shu3
Hopefully will have Been to MOT centre one way or another in the next week. Will let you know what was said about it then.
Only my old discovery I tried using both velcro and magnets to hold the number plate to the winch bumper (so that it could be removed for using the winch or pandp sites) but neither we able to stand up to water crossings or spray off deep puddles.
-
- Winching along now
- Posts: 731
- Joined: Sat Aug 09, 2014 11:05 am
Re: Number plate relocation
Might work?
STAINLESS STEEL NUMBER PLATE HOLDER USING SPRING LOADED CATCH
https://www.ebay.co.uk/itm/122563599647
STAINLESS STEEL NUMBER PLATE HOLDER USING SPRING LOADED CATCH
https://www.ebay.co.uk/itm/122563599647
- combatkenz
- Got muddy boots
- Posts: 24
- Joined: Mon May 29, 2017 11:24 am
Re: Number plate relocation
Larry,Larry wrote: ↑Sun Mar 04, 2018 8:34 amhttps://flic.kr/p/23vhiYK
https://flic.kr/p/227shu3
Hopefully will have Been to MOT centre one way or another in the next week. Will let you know what was said about it then.
Only my old discovery I tried using both velcro and magnets to hold the number plate to the winch bumper (so that it could be removed for using the winch or pandp sites) but neither we able to stand up to water crossings or spray off deep puddles.
That's how I want to mount mine so please let me know how you get on . It looks good to me and it's clearly visible so you should be fine. I've heard something about the plate needing to be reflective and obviously spacing and font needs to be correct.
- donkeychomp
- I spend far too much time on here
- Posts: 3582
- Joined: Thu Aug 18, 2011 3:49 pm
- Location: Shepperton, Middx
Re: Number plate relocation
MOT won't cover number plates. That is illegal and it cost me £60 to find out. Up to you though....
If it ticks over...leave it