Few work photos

A place to post all your pictures and videos or links to any you've found on the tinterweb that you think people will enjoy.
only one rule, no nakedness but make it as dirty as you like! (In the muddy kind of way)
Post Reply
User avatar
Tramp
Suzuki, will you marry me?
Suzuki, will you marry me?
Posts: 2828
Joined: Fri Jul 25, 2008 10:09 pm
Location: Rotherham - South Yorkshire

Re: Few work photos

Post by Tramp » Sat May 18, 2013 4:34 pm

Cottam, on the Trent, not far from retford,

User avatar
Ricky-410
Engaged 4wd low
Engaged 4wd low
Posts: 205
Joined: Sun Oct 07, 2012 11:45 pm
Location: West Cumbria

Re: Few work photos

Post by Ricky-410 » Mon May 20, 2013 11:43 pm

Were on the A66 in the wagon today jordi? saw a john dickinson wagon with a low loader on like in the photos on the way to hospital before. (or it might of been the A1, cant remember!)

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Few work photos

Post by Jordi » Mon May 20, 2013 11:44 pm

Nah, been down to Southampton.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
Jordi
Bow down before me
Bow down before me
Posts: 7535
Joined: Sun Nov 29, 2009 2:35 pm
Location: Darlington, Co. Durham

Re: Few work photos

Post by Jordi » Tue May 21, 2013 4:14 pm

Todays wee job.

14' wide cooling tower section Worcester to Middlesbrough.
image.jpg
image.jpg (2.11 MiB) Viewed 8359 times
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank

User avatar
Edweird
Suzuki, will you marry me?
Suzuki, will you marry me?
Posts: 2531
Joined: Sat Jan 23, 2010 11:04 pm
Location: Brigg, North Lincolnshire

Re: Few work photos

Post by Edweird » Tue May 21, 2013 4:18 pm

Jordi's coming. Watch out, wide load. :brows:
There's three ways of doing things:

The right way,
The wrong way
And my way, which is like the wrong way but faster.

User avatar
palmer
Got muddy boots
Got muddy boots
Posts: 91
Joined: Sun Apr 15, 2012 7:11 pm
Location: bury st edmunds, suffolk

Re: Few work photos

Post by palmer » Wed May 22, 2013 7:05 am

Here is my daily drive at work a 1993 tractor wheeled case 721 ex army loading shovel, as you can see in the picture comes in handy moving crap :hahaha:
Attachments
62607_152012584979532_1287653642_n.jpg
62607_152012584979532_1287653642_n.jpg (23.46 KiB) Viewed 8344 times
1.3 engine
Webber carb
Roll cage
Spoa
32 mm wheelspacers
Extended brake lines
31" Bronco Grizzerly Claws

MONSTER ENERGY DISCO KILLER!!

User avatar
Tramp
Suzuki, will you marry me?
Suzuki, will you marry me?
Posts: 2828
Joined: Fri Jul 25, 2008 10:09 pm
Location: Rotherham - South Yorkshire

Re: Few work photos

Post by Tramp » Wed May 22, 2013 7:24 am

Awesome I love wheel loaders / shovels, fantastic bits of kit, when i worked at the steelworks we had a few, they were great all round useful mobile plant, we would use them to lift& rerail derailed scrap transfer cars. It was always good to see them lift the rear wheels! I always wanted to drive one, that & a kress! When I was an apprentice I had a stint in the mobile plant workshop, my first job was to grease the pivot points on the slagpot kress. Me being keen climbed up and greased them all, when I got down I was absolutely filthy. Later I was to learn that these pivot points only got greased when they had someone new in the department!

Image
Not the kress I worked on (ours were for slagpots not ladels so the back was smaller) but you get the idea the front wheels are taller than me! They had gear reduction inside the wheels, they also had something like 14 gears but had to have the top 7 blanked as the drivers were taking them too fast!

User avatar
turbo-tom
I spend far too much time on here
I spend far too much time on here
Posts: 4478
Joined: Fri Jun 25, 2010 9:29 pm
Location: West Sussex

Re: Few work photos

Post by turbo-tom » Wed May 22, 2013 7:05 pm

hahah at palmer go on dump it on the scrap pile! but keep the engine and scrap the rest! ;)
Tom :)

Ford Fiesta ST :D

User avatar
windsor
Winching along now
Winching along now
Posts: 618
Joined: Fri May 17, 2013 7:58 am
Location: derbyshire

Re: Few work photos

Post by windsor » Wed May 22, 2013 7:18 pm

I dont get to work with truks but strange animals
Attachments
20130501_150532.jpg
20130501_150532.jpg (3.38 MiB) Viewed 8321 times
20130429_191928.jpg
20130429_191928.jpg (1.12 MiB) Viewed 8321 times
1994 sj 413 sierra
cheker plate door cards
cd players
asin free wheeling hubs
99% rust free
alloys
bukets
some leaks here and there

User avatar
dazerede
Suzuki, will you marry me?
Suzuki, will you marry me?
Posts: 2141
Joined: Fri Sep 30, 2011 10:23 pm
Location: cornwall callington

Re: Few work photos

Post by dazerede » Wed May 22, 2013 7:30 pm

This is what I helped put up at work a qouple of weeks ago

Enjoy
Attachments
IMAG0214.jpg
IMAG0214.jpg (689.21 KiB) Viewed 8314 times
IMAG0090.jpg
IMAG0090.jpg (1.03 MiB) Viewed 8314 times
Suzuki Sj 410 Jap Built
Recaro Seats Fitted
Landini Blue Colour
Full rollcage and winch bumper
1.6 8v vitara lump with su carb
4” calmini lift kit :)
235/75/15 insa turbo special tracks
99.9% Rust Free
BUILT NOT BOUGHT

Post Reply