Page 44 of 72
Re: the no dosh LJ revamp
Posted: Fri Jul 21, 2017 9:13 pm
by donkeychomp
Made a start on the inside today, and the number plate light got done too, it was covered in tiny scratches but some fine wet and dry got that sorted. I will be making some panels for both sides and the floor, the roll hoop will probably have to come out to do it properly, might even get that blasted then powder coated.
Re: the no dosh LJ revamp
Posted: Fri Jul 21, 2017 10:05 pm
by ROBBIE
Looking good as always
Re: the no dosh LJ revamp
Posted: Fri Jul 28, 2017 12:10 am
by donkeychomp
Finished the other side in this so called 'summer' weather. Need to go get some MDF next. And the Pro Comps are all done ready to go on. Also ordered some new brake shoes for the next MOT, matey mentioned they were ok but not brilliant...and I need to do something about those holes!
Re: the no dosh LJ revamp
Posted: Mon Jul 31, 2017 1:37 pm
by Anton
Re: the no dosh LJ revamp
Posted: Tue Aug 01, 2017 11:10 pm
by donkeychomp
Bit of routine door maintenance...
Re: the no dosh LJ revamp
Posted: Thu Aug 03, 2017 9:32 pm
by donkeychomp
Still at it with this door, gave it a coat of primer to see if there were any imperfections. Short answer, yes. Loads of filler later and I'm stil not done!
Re: the no dosh LJ revamp
Posted: Thu Aug 03, 2017 11:20 pm
by SlimGrim
Yes dude this looks mint!
Re: the no dosh LJ revamp
Posted: Fri Aug 04, 2017 12:06 am
by donkeychomp
Mint? Well it is a sort of mint green....
Re: the no dosh LJ revamp
Posted: Fri Aug 04, 2017 7:13 am
by Jordi
I prefer dents Alex.
Re: the no dosh LJ revamp
Posted: Fri Aug 04, 2017 9:04 pm
by donkeychomp
I have a selection of hammers should you require extra dents...
