Suzuki Club UK

Morning

Just wondering if somebody has a link of where to i can get the 4 rocker cover bolts for my sj413 , i just noticed an oil leak from the front corner and went to nip up the bolts but the front left one was sheared off when i went to tighten it ..... I have tried ebay but nothing but Gaskets but no bolts

and anybody know what torque these should be set to ?

My approach of tight and re-tight didn't work this time

thanks

Is this what you are looking for:
http://www.autodoc.co.uk/car-parts/cyli ... 413/sierra

Here is a great page for torque info:
http://www.suzukiclubuk.co.uk/tech-spec ... olt-torque

I can't find any for sale online

You could try Suzuki UK or ask someone here who's breaking an SJ. As for tightening them just do them up and not too much either. They certainly don't need torquing down!

Theres a small chance I might have some if you can't find any new ones. I will have to have a good hunt if so.

About £20 from the states on Ebay, probably not a lot more though from your local main dealer?

Valve Cover Bolt & Washer Set




http://www.ebay.co.uk/itm/301880144839

SherwoodNash wrote:About £20 from the states on Ebay, probably not a lot more though from your local main dealer?

Valve Cover Bolt & Washer Set




http://www.ebay.co.uk/itm/301880144839

Thanks ill check these out , a bit pricey for a bolt when you add the carriage but i suppose there worth it , thanks for all the help

Darrell wrote:I can't find any for sale online

Yup neither can i except from the states , i am wondering would some 6mm s/s treaded bar do the job instead ..

I have loads of spare ones