kentish newbie?
kentish newbie?
evening gents.. been browsing your ace forum for about a year now or since i climbed off my life thretening yamaha r1 (lose life or licence)and became the proud owner of a Ereg sj 410 tin top with a very tired mk1 1324cc swift engine on a 5 speed sammi box, hif38 thought it was a 44 till i measured it??
thanks to your how to guide i replaced the rear wheel bearings, changed two uj's (now with nipples), polly bushed and patched(blown holes in?) a few areas but ive just brought a cheap vitara purely for its fat boy alloys and 1.6 8v carb engine it runs fine but does have a blown head gasket and cracked exhaust manifold hoping to do the swap soon as the 1.3 also has a v blown head gasket and has very little compression. still managing to nurse her about as i need the sj for work(8w tipper driver) so im hoping to tap into the vast wealth of knowledge that is suzuki club uk??
1st Q. the 2 wires black with white stripe and black that go into the vitara carb on a green clip connecter what are they for?? auto choke?? not got anything on the sj to accomodate?? will post some pics when i work out how ??
thanks to your how to guide i replaced the rear wheel bearings, changed two uj's (now with nipples), polly bushed and patched(blown holes in?) a few areas but ive just brought a cheap vitara purely for its fat boy alloys and 1.6 8v carb engine it runs fine but does have a blown head gasket and cracked exhaust manifold hoping to do the swap soon as the 1.3 also has a v blown head gasket and has very little compression. still managing to nurse her about as i need the sj for work(8w tipper driver) so im hoping to tap into the vast wealth of knowledge that is suzuki club uk??
1st Q. the 2 wires black with white stripe and black that go into the vitara carb on a green clip connecter what are they for?? auto choke?? not got anything on the sj to accomodate?? will post some pics when i work out how ??
- Attachments
-
- the busy garage?
- WP_000016.jpg (1.85 MiB) Viewed 7575 times
drive it like you stole it...
- Jordi
- Bow down before me
- Posts: 7534
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: kentish newbie?
Welcome to SCUK.
Good to see another Zuk being resurected, and not for the first time by the sounds of it.
Jordi
Good to see another Zuk being resurected, and not for the first time by the sounds of it.
Jordi
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank
Re: kentish newbie?
to club UK matey, glad our site has been a lot of help I might be interested in your tired old swift gti engine if its for sale where in the UK are you?
As for the green plug it should be the fuel stop solenoid (if it screws into the carb on the rocker cover side of the carb?) just find a black w/white tracer in your loom (ignition +) and join it to that and earth the black wire, I used the other half of the green connector cut off the bit loom when I did mine so I could easily disconnect it and keep it factory looking.
As for the green plug it should be the fuel stop solenoid (if it screws into the carb on the rocker cover side of the carb?) just find a black w/white tracer in your loom (ignition +) and join it to that and earth the black wire, I used the other half of the green connector cut off the bit loom when I did mine so I could easily disconnect it and keep it factory looking.
- dan_2k_uk
- I spend far too much time on here
- Posts: 4924
- Joined: Tue May 06, 2008 5:19 pm
- Location: Swindon, Wiltshire
Re: kentish newbie?
Janspeed manifold, LWB Vit vented discs and calipers
Build thread -- Build photos -- HLA-Artwork
Coming soon: YJs, Trussed axles, Full float rear.
- ROBBIE
- I spend far too much time on here
- Posts: 4555
- Joined: Tue Sep 09, 2008 6:32 pm
- Location: Dorset or stuck
Re: kentish newbie?
Hi
Sid James gone but never forgotten
Jimny 1.6 not as good as an SJ but still good
Jimny 1.6 not as good as an SJ but still good
- dazerede
- Suzuki, will you marry me?
- Posts: 2141
- Joined: Fri Sep 30, 2011 10:23 pm
- Location: cornwall callington
Re: kentish newbie?
welcome to suzuki clubuk
we love pics
we love pics
Suzuki Sj 410 Jap Built
Recaro Seats Fitted
Landini Blue Colour
Full rollcage and winch bumper
1.6 8v vitara lump with su carb
4” calmini lift kit
235/75/15 insa turbo special tracks
99.9% Rust Free
BUILT NOT BOUGHT
Recaro Seats Fitted
Landini Blue Colour
Full rollcage and winch bumper
1.6 8v vitara lump with su carb
4” calmini lift kit
235/75/15 insa turbo special tracks
99.9% Rust Free
BUILT NOT BOUGHT
- turbo-tom
- I spend far too much time on here
- Posts: 4478
- Joined: Fri Jun 25, 2010 9:29 pm
- Location: West Sussex
Re: kentish newbie?
Tom
Ford Fiesta ST
Ford Fiesta ST
Re: kentish newbie?
to the club .
86 SJ413 tin top, 1.6 8v, SU carb, YJ spring conversion, virtual lift, 33x12.5x15 KL71's, rocklobster, rear discs, power steering.
Re: kentish newbie?
to the club
Re: kentish newbie?
cheers for the warm welcome its good to be around like minded nutters (sorry fellow sj owners!)
cheers scottiej for the plug tip will add it to my huge todo list??
cheers scottiej for the plug tip will add it to my huge todo list??
- Attachments
-
- WP_000002.jpg (1.74 MiB) Viewed 7474 times
drive it like you stole it...