HELP

OllieSJ · Post by **OllieSJ** » Sun May 26, 2013 7:42 pm

So this has confused me of how to get it off ??

suzukisteve · Post by **suzukisteve** » Sun May 26, 2013 7:44 pm

the spacer itself should pull off then you can unwind the studs after. if its stuck on give it a good squirt up with wd40 or the equivalent and leave to soak in for a bit and try again

OllieSJ · Post by **OllieSJ** » Sun May 26, 2013 7:48 pm

oh okay i think they may be stuck then as they have been soaked in clay thanks

OllieSJ · Post by **OllieSJ** » Mon May 27, 2013 1:22 pm

How do i get these bits of now ??

Post by **dan_2k_uk** » Mon May 27, 2013 2:16 pm

With a bar put across 2 and levering against the floor to stop the hub spinning just use a deep socket or a ring spanner.

Darrell · Post by **Darrell** » Mon May 27, 2013 2:26 pm

Or get someone to put their foot on the brake

turbo-tom · Post by **turbo-tom** » Mon May 27, 2013 11:14 pm

or get a rattle gun and buzz them off!

OllieSJ · Post by **OllieSJ** » Mon May 27, 2013 11:16 pm

Nearly done them all with an adjustable and a nice slice out of my finger

Post by **Jordi** » Mon May 27, 2013 11:23 pm

Bleeding it all part of the experience Ollie. By the end of the week i'll lucky to have skin on my hands.

Post by **ScottieJ** » Mon May 27, 2013 11:29 pm

Ollie you want to get yourself a decent socket set and set of spanners (at least 8-19mm) before you buy any more parts, adjustable spanners shouldn't go anywhere near a vehicle unless its an emergency, they are aweful things and spend most of their life rounding off bolts rather than undoing them, I've got a large selection of adjustable spanners and I can't actually remember the last time I used one

Oh and this should be in wheels, tyres and brakes not the bar

Suzuki Club UK

HELP

HELP

Re: Spacer on the car only quick and probs simple

Re: Spacer on the car only quick and probs simple

Re: Spacer on the car only quick and probs simple

Re: HELP

Re: HELP

Re: HELP

Re: HELP

Re: HELP

Re: HELP

test