Hi
I'm buying an SJ413 here in Spain. I need an ignition module (the black box thingumies that are attached to the distributor that replace the function of the points on an older vehicle). The module in the vehicle I'm looking at is blown. I've tried the local Suzuki dealer who says that there are no new parts. The local scrap yards are drawing a blank.
I need to source one from, e.g. mail order from U.K. or does anybody know any alternatives, e.g. an equivalent part I could pull off another vehicle that should fit the distributor or an aftermarket kit or from a scrap specialist? The unit comprises a pickup coil connected to a module containing the transistor switching module that switches the low tension side of the coil.
I just need something to get going - I'd even fit an old points style distributor if that would get me going - after that I can work on a less-bodgy solution - if necessary!
Cheers
Marcus
SJ413 1989 Ignition Module - Where?
- Darrell
- Suzuki, will you marry me?
- Posts: 2989
- Joined: Wed Feb 23, 2011 7:54 pm
- Location: south oxfordshire
- Contact:
Re: SJ413 1989 Ignition Module - Where?
I can't find anybody selling the generator assembly. I think you may be best to try and find a used distributor complete and use it or rob the part required.
- Attachments
-
- dizzy.png (235.36 KiB) Viewed 7070 times
2005-GV 1600se, "Hell" What do I know!
- Darrell
- Suzuki, will you marry me?
- Posts: 2989
- Joined: Wed Feb 23, 2011 7:54 pm
- Location: south oxfordshire
- Contact:
Re: SJ413 1989 Ignition Module - Where?
On some I believe the generator and ignitor are connected by 2 screws (as shown above) but not listed as separate part numbers.
Mine are soldered together like this
Mine are soldered together like this
- Attachments
-
- 20140406_143405_zps44a43791.jpg (83.87 KiB) Viewed 7067 times
2005-GV 1600se, "Hell" What do I know!
Re: SJ413 1989 Ignition Module - Where?
I think the 'Do not Remove' marking gives a clue as to why its not available separately, I would recommend seeking out a used, complete, distributor.
2006 Jimny JLX+ 1.3 VVT
2000 Vitara 4u2 - Calmini 3+3, 33" MTs, 5:83 R&Ps, winch bumper, remapped ECU.
1986 Suzuki SJ413K - G16 conversion
1984 Suzuki SJ410 - Blitz
2000 Vitara 4u2 - Calmini 3+3, 33" MTs, 5:83 R&Ps, winch bumper, remapped ECU.
1986 Suzuki SJ413K - G16 conversion
1984 Suzuki SJ410 - Blitz
- Darrell
- Suzuki, will you marry me?
- Posts: 2989
- Joined: Wed Feb 23, 2011 7:54 pm
- Location: south oxfordshire
- Contact:
Re: SJ413 1989 Ignition Module - Where?
I always assumed "do not remove" ment the dust covers ??
2005-GV 1600se, "Hell" What do I know!
Re: SJ413 1989 Ignition Module - Where?
Would an SJ410 distributor fit? Or an older, points-style distributor (assuming that earlier MY's had those) from SJ413 fit? I want to widen my net!
Re: SJ413 1989 Ignition Module - Where?
Jordi! You tried to send me a PM, matey. Apparently I'm not 'sufficiently active' on the forum to be allowed to even read a PM yet. :(
Last edited by marcusj on Tue Aug 26, 2014 12:02 pm, edited 1 time in total.
- Jordi
- Bow down before me
- Posts: 7534
- Joined: Sun Nov 29, 2009 2:35 pm
- Location: Darlington, Co. Durham
Re: SJ413 1989 Ignition Module - Where?
Should be able to read it now.
1988 Samurai - Truck Cab & Tray Back - 1.6 8v & HIF44 - Snorkel - Stack Exhaust - PAS, YJs & 33s - Trussed, Gusseted & Pumpkin Capped Axles - 4.3 R&Ps - 4.16 T/Box - Rear Air Locker - Full Float Back Axle & Discs - RCV Front Shafts - X-Eng Handbrake - Custom Fuel Tank